Doosan LIGHTSOURCE V9, Operation And Maintenance Manual

Page: 22 / 66

OPERATING INSTRUCTIONS
18
LIGHTSOURCE V9
STARTING THE ENGINE
1. The Main Circuit Breaker and Lamp switches should be “OFF”.
2. Turn the Ignition Switch to “PREHEAT“ for 5 seconds prior to
starting.
NOTE: In extreme cold temperatures, this may take up to 10 seconds.
WARNING: Electrical power is present upon cranking engine.
3. Immediately turn the Ignition Switch to “START”.
NOTE: DO NOT crank for more than 15 seconds without allowing the
starter to cool for 30 seconds. If the engine does not start after a few
attempts, refer to “Fault finding”.
4. Release the Ignition Switch to “ON“ as soon as the engine
continues to run.
5. Allow the engine to warm up for 3 to 5 minutes.
6. Turn on the main circuit breaker.
7. The Lamp Switches may now be used.
WARNING: Keep side doors closed for optimum cooling and
safety of unit while running.
NOTE: The engine in this unit is protected with sensors for high coolant
temperature and low oil pressure. Should either of these conditions
occur, the engine will automatically stop causing a loss of power to all
lamps. Before restarting the unit, check the fuel level and
engine/radiator thoroughly and correct the problem. The lamps should
not be restarted for 15 minutes.
SOCKET OUTLETS
With engine running:
1. Turn on the socket breakers.
2. Plug the equiptment in to the sockets.
NOTE: The maximum total socket outlet is 26Amps @ 230Volts with
all lights off. Each socket rating is 16Amps @ 230Volts.
STOPPING THE ENGINE
1. Turn the Lamps “OFF”.
2. Turn the socket breakers “OFF” if they are on.
3. Turn the Main Breaker “OFF”.
4. Turn the Ignition Switch “OFF”.
NOTE: If the lights are turned off, they should not be restarted for 15
minutes.