9150-065-M-5-18
10
1.4 Operator Mounting Positions
•
Operator’s chain idler wheels are factory set
for the front position.
•
Remove only the top chain knockouts from
each side of the operator.
•
Chain stops or gate end retainer can be
used as the physical stop for the gate
(Chain stops are shown).
Front Position with Concrete Pad
Standard method of installation.
Chain
Stop
Chain Idler
Wheels
Chain Idler
Wheels
Chain
Stop
Gate End Retainer
Gate End
Retainer
Gate End Retainer
Top View
Top View
Additional hardware required.
Post base plate (P/N 2600-495) 6 x 6 steel posts not available from DoorKing.
Base plate stop brackets (P/N 2600-970) bolts on post base plate when using chain stops.
Optional chain tray kit (P/N 2601-270 10 ft section) and additional chain #40 (P/N 2600-442 - 20 ft. per box) may be needed.
•
Set operator chain idler wheels in the
bottom
position.
•
DO NOT
remove chain knockouts.
•
Chain stops with base plate stop
brackets or gate end retainer can be
used as the physical stop for the gate
(Both are shown, only one type is
needed).
Base Plate
Stop Bracket
Chain Setup
Chain Setup
The Model 9150 operator is designed to be installed in the front, rear, center or ceiling mounting positions shown on this page
and the next 3 pages. V-wheel V-rail ornamental gates are shown as examples but other gate types on the previous page can
use the same mounting setups. Once the mounting position has been determined, the chain idler wheels may need to be
adjusted
BEFORE
the operator is mounted.
Physical stops MUST be used in the open AND close positions for ANY gate
installation (Chain stops, end posts with gate end retainers or a wall that the gate comes in contact with).
A filler post or barrier may need to be
installed between the gate and wall area
(See page 2 for more information).
A filler post or barrier may need to be
installed between the gate and wall area
(See page 2 for more information).
Front Position with Post Mount
Raises operator and allows different chain heights. Optional chain tray kit can be used and is recommended for gates over 20 ft,
supports the chain’s weight and helps prevent chain “stretching”.
See page 17 for more information.
Summary of Contents for 9150-080
Page 50: ...9150 065 M 5 18 46...