DONPER
USA
—USER MANUAL
15 — COPYRIGHT DONPER USA 2015
OPERATING IN THE AUTO MODE:
There are two Auto bu ons on the front control panel, one for the le
barrel and one for the right cylinder. The two sides can be controlled in
‐
dependently of each other. Press the Auto bu on on the control panel
to begin freezing inside the corresponding freezing cylinder. When in
Auto Mode, the indicator light will turn on along with the corresponding
beater motor. The numeral values on the display will increase from 0 to
99 and then stop at 00. When the number value reaches 00, this indi
‐
cates that the product in the freezing cylinder is ready to serve. When
the number reaches 00, the indicator light above the AUTO bu on will
then
fl
ash, indica ng that the product is ready and has reached the de
‐
sired
fi
rmness level. Note that the hopper cooling switch should also be
turned on during the AUTO mode opera on to keep the product in the
hoppers refrigerated and to prevent spoiling.
NEVER RUN THE MACHINE
IN AUTO MODE WITH WATER IN THE FREEZING CYLINDERS—DAMAGE
WILL OCCUR.
Adjus ng the Product Firmness Level:
With the Power Switch ON and both Auto bu ons OFF, press the up and
down bu ons simultaneously and hold for 5 seconds (machine will beep
5 mes) for the side you wish to adjust. A numerical value of 1 to 10
(the
fi
rmness se ng) will begin to
fl
ash on the screen. Use the up and
down bu ons to adjust the
fi
rmness se ng with 1 being so er product
and 10 being
fi
rmer product. Once the
fi
rmness is set, the control panel
will automa cally return back to “00” a er about 10 seconds of no fur
‐
ther adjustments.
