Dong Feng ZB25, Operator'S Manual

Page: 29 / 112

Factory Direct Tractors
Front End Loader Safety
1.3 Safety Decals
Care of Safety Decals
1.
Keep safety decals clean and free of obstructing material.
2.
Replace damaged or missing safety decals with new decals from your dealer.
3.
If a component with a safety decals(s) affixed is replaced with a new part, ensure new safety
decal(s) are attached in the same locations on the replacement components.
Refer below for correct location of decals. Note decals appear on both sides of loader.
S-24
•
Do not use a bucket to scrape or as a dozer blade, unless the bucket is titled so that the bucket stops
are in contact with the boom. A limited amount of leveling may be done, when the loader valve is
arranged with a float control. This will prevent damage to cylinder rods.
•
Care must be taken with your loader cylinders. Always keep cylinders in a retracted position when the
loader is not in use to guard against rust and contamination which may cause damage to the cylinder
rods or hydraulic system.
• Hydraulics:
When parking the tractor, release the hydraulic pressure by shutting down the engine
and place the loader control lever into the ‘Float’ position. After five seconds, replace the lever to the
neutral position.
Note:
Do not operate the three point linkage with the loader control in float position.