Donaldson Torit DFO 2-4, Installation And Operation Manual

Page: 20 / 44

17
Donaldson Company, Inc.
5. Slide the filter out the access port along the
suspension yoke and dispose of properly.
6. Clean the sealing surface with damp cloth.
Clean dust from gasket sealing
area to ensure a positive filter
gasket seal.
7. Check for an accumulation of dust in the storage
area and empty as necessary.
Filter Installation
1. Slide the new filter cartridges onto each suspension
yoke.
Note: Insert the filter gasket end first.
2. Wipe cover gaskets clean and replace covers by
attaching cover to yoke hook and firmly latching
cover handle.
Replace access covers carefully by securing them
using the handle provided. Keep fingers away from
the sealing surface to avoid pinching.
Check that access covers
are seated and seal properly.
Gaskets must be compressed to ensure an
airtight seal.
3. Turn electrical power and compressed air supply ON
before starting unit.
Dust Disposal
1. Turn unit OFF and empty dust container as necessary
to minimize dust in the hopper.
2. If the optional 55-gallon drum attachment is used,
empty when drum is 2/3 full.
3. If optional slide gate is used, close gate before
servicing drum.
4. Reinstall drum and open gate (if applicable).
Compressed Air Components
Do not set compressed-air
pressure above 100-psig.
Component damage can occur.
1. Periodically check the compressed air components
and replace compressed-air filter.
2. Drain moisture following the manufacturer’s
instructions.
3. With the compressed-air supply ON, check the
cleaning valves, solenoid valves, and tubing for
leaks. Replace as necessary.
NOTICE
NOTICE
NOTICE