Domino V100, Operation And Maintenance Manual

Page: 153 / 291

OPERATION
(3) Slope Type
(
CM
)
Controls the acceleration/deceleration of the ribbon motor. The acceleratio
deceleration is determined by the speed of the web; A higher web spee
and smooth
n/
d yields a slow
acceleration, whereas a low web speed yields an almost instantaneous
speed and
f printing
ation) and possibly ending up with a broken ribbon,
For cases like this, set it to manual and type in the maximum web speed in the edit
just below.
ection, and hence allows
pact the print quality, but in reality the transfer of ink
to the web is often improved and the total print quality is improved.
speeds above 700 mm/second, it is recommended to test if enabling
ves the print quality.
(5) Print Speed
400 )
To do this press the “default” button once.
Notice that the button is now reversed
When the default button is reversed press the setting you wish to reset.
If the default button is accidentally pushed, press it again to deselect the button.
acceleration.
When slope type is set to auto, the printer will monitor the current web
calculate an appropriate acceleration.
Under some circumstances, it is not possible to measure the web speed (i
during the web’s acceler
box that appears
(4) Fast Mode
(
CM and V400
)
Fast mode actually reduces the resolution in the printing dir
the system to print in excess of 1000 mm/second.
Reducing the resolution can im
When printing at
fast mode impro
( V100 and V
Use this setting to define the printing speed.
(6) Default
The default button allows the reset of a single setting to the factory default.
27864 Issue 1January 2008 (153)