EN
CombiPower
Switching the device on and off
91
8
Switching the device on and off
I
NOTE
The main switch (fig.
1
10, page 3) on the device must be in the
“I” position.
➤
Press the “ON/OFF” button (fig.
3
2, page 4) on the remote control.
✓
The device is switched on and the message “System Initialisation …”
appears in the display.
✓
After a few seconds, the display shows the message “System startup
please wait…”.
The system status is checked.
✓
After 5 to 10 seconds, the display is ready and shows the status of the
device:
– The device is ready for use: the display shows operating parameters.
– Alarm messages are present: undervoltage, overload, fan failure,
overtemperature
– Faults have occurred: undervoltage (UVP), overvoltage (OVP), over-
temperature (OTP), overload (OLP)
9
Configuring the device with the
remote control
9.1
Basic information
Access to the “Another Param” menu, with which you can make the basic
settings, is password-protected. The default password is “0000”.
Opening setup mode
➤
Switch on the device (see chapter “Switching the device on and off” on
page 91).
➤
Press the “
” button on the remote control for longer than 2 seconds.
✓
You are now in setup mode.
_CombiPower_IA_DE-IT.book Seite 91 Freitag, 21. Oktober 2011 8:10 20
