Dometic SINEPOWER MCP1204, Operating Manual

Page: 17 / 284

EN
PerfectCharge MCP1204/1207 Using accessories
17
7.2 Using the battery charger
➤
Select the required mode:
Mode 1 (battery is connected) : Press the button for 1 s.
Mode 2 (battery is connected): Press the button for 5 s.
Mode 3 (battery is not connected): Press the button for 10 s.
✓
The charging process starts in mode 1 and 2.
A constant voltage supply is started in mode 3.
✓
The LEDs show the charging progress of the battery of the battery charger (see
chapter “Status indications” on page 14).
➤
To end the charging process, press the button once again.
I
8 Using accessories
I
8.1 Storing the battery charger in the wall bracket
Installation instructions
When selecting the installation location for the wall bracket, observe the following
information:
•
The wall bracket must be installed in a location protected from moisture.
•
The wall bracket may not be installed in areas containing flammable materials.
•
The wall bracket may not be installed in dusty environments.
•
The device must be installed on a level and sufficiently sturdy surface.
NOTE
When the red LED flashes because the battery voltage is under 9 V, you
can charge the battery to over 9 V in mode 3. To do this, disconnect the
battery and switch to mode 3. Once the battery has been charged over
9 V, you can switch the battery charger to mode 1 or 2 again to start
normal charging.
NOTE
Accessories are not included in the scope of delivery.
If you have questions regarding the accessories, please contact your
local service partner.
MCP1204-1207--O-16s.book Seite 17 Freitag, 10. März 2017 12:04 12