Dometic RO400, User Instructions

Page: 23 / 136

23
Connecting the reject water hose
The reject water hose (for discharge of water to a household
waste pipe) can be extended up to 4 metres. The smallest inter-
nal diameter is 13 mm. The bracket (supplied) should be secured
at a height of at least 50 mm and a maximum of 500 mm above
the top of the appliance.
Connection to a waste pipe with a trap can be made if
the trap has an entry point of the type used for a dish-
washer discharge. If there is only one entry point and
this is already in use, the connector unit will need to
be changed, and one with two entry points used
instead. The reject connector from the water purifier
should be before the drain. The reject water hose
needs to be routed in a curve up the underside of the
worktop or sink bench. Fix the hose securely in place
as shown in Fig.
A , using one of the hose clips and
the bracket supplied.
Connecting the feed water hose
Make sure that the black washers are in place when
securing the connectors at both ends of this hose.
Screw the straight end of the feed water hose onto the
shut-off valve(see Fig.
B ).
If the 3/4
"
hose connection does not fit, it can be
changed to a 1/2
"
connection using the adapter sup-
plied. Put the black washer in the adapter and screw
the adapter onto the shut-off valve for feed water.
Screw the feed water hose onto the adapter.
INSTALLATION
A
B