EN
RM5310, RM5330, RM5380
Cleaning and maintenance
101
9
Cleaning and maintenance
!
A
➤
Clean the interior and exterior of the device occasionally with a damp
cloth.
➤
Make sure that the air inlet and outlet vents on the device are free of any
dust and dirt, so that heat can be released and the device is not damaged.
10
Maintenance
!
I
➤
After putting the device into use for the first time, and then at two-year
intervals, have the gas installation and the connected exhaust gas guides
inspected by an authorised expert for compliance with standard EN 1949.
➤
The gas burner must be cleaned to remove soiling when necessary, but
at least once a year. If liquefied petroleum gas (tank or refillable cylinders)
is used, the maintenance interval is shorter, and maintenance must be
performed every three or six months, depending on the degree of soiling.
This can be identified from a reduced cooling capacity in gas mode.
➤
Keep the documentation proving completed maintenance of your
refrigerator.
WARNING!
Always disconnect the device from the mains before you clean
and service it.
NOTICE! Beware of damage
Do not bring the door seal into contact with oil or fat.
Do not use abrasive cleaning agents or hard objects during
cleaning as these can damage the cooling device.
WARNING!
Work on gas and electronic installations may only be performed
by a certified specialist.
NOTE
Have the refrigerator serviced after the vehicle has been out of
commission for a longer period of time. Contact customer service
to do so.
