7
EN
PRO TRIM™ Single/Dual Bezel Switch Assembly Installation
q
q
9
Rack Steering System Drill Locations
q
Rack Steering System Drill Locations
2. Place the switch assembly bracket against the plastic
bezel and mark the holes indicated in Figure 9.
3. Drill two 3/16 in. diameter holes where marked on
the plastic bezel.
I
If your bezel already has recessed holes at these
locations, then no drilling of the bezel is necessary.
10
Rack Steering System Wire Passage—Option 1 Holes
4. Provide a passageway for the wires to the inside or
underside of the dash. This can be done one of two
ways:
Option 1. Allow the wires to pass through the dash
and not be concealed by the bezel. Drill
one or two 3/8 in. diameter holes (one
required for single switch; two required for
dual switch) through the dash.
Option 2. Allow passage of the wires underneath the
dash. Drilling holes is not required.
I
If installing a single switch, be sure the hole is
drilled on the side the switch lever will be installed.
5. Attach the wires to the switch; red wire to the center
terminal, green wire to the top terminal, and blue
wire to the bottom terminal (see Figure 2).
e
q
w
11
Remove the Bezel
q
Bezel
e
Steering Wheel Shaft
w
Countersunk Holes
6. Remove the bezel from the steering wheel shaft,
taking care to leave the attachment screws in the
countersunk holes of the bezel.
r
q
w
e
12
Attach the Bezel
q
Bezel
e
Screws
w
Switch Assembly
r
Steering Wheel Shaft
7. Attach the switch assembly to the bezel using the
screws provided:
a. If the bezel has no recessed holes, use two
7/16 in. screws and lock nuts (provided).
b. If the bezel has recessed holes, use two 5/8 in.
self-tapping screws (provided).
