12
EN
Final Adjustments
PRO TRIM™ Single/Dual Bezel Switch Assembly
5 .6 Testing the Installation
This section describes the proper procedure to test the
installation of the switch assembly.
1. When installed for control of engine trim or jack
plate operation, make sure the engine moves in the
direction you expect when the switch is activated.
– Push the lever up to make the engine tilt or move
upward.
– Push the lever down to make the engine tilt or
move downward.
2. When installed for horn operation, operate the
switch in both directions and check that the horn
functions.
3. If the switch assembly is not working properly,
perform the following checks:
a. Check the wire connections at the toggle switch.
b. Check the wire connections at the wire harness.
I
Go to www.dometic.com to find technical support
in your area.
4. If applicable, check the functionality of the marine
craft’s original dash or control mounted trim switch
to ensure it is still working properly.
5. If all systems are working properly, make a final
inspection of the wire connections.
6. Wrap the wiring assembly with a quality electrical
tape (not provided) to keep connections clean and
secure.
6 Final Adjustments
This section describes the proper procedure for
reinstalling the steering wheel and making any final
adjustments to the switch assembly.
6 .1 Reinstalling the Steering Wheel
Reinstall the steering wheel using the hardware removed
with the steering wheel. Refer to your steering system
and wheel manufacturer instructions to insure proper
installation of the steering components.
6 .2 Adjusting the Lever Distance
I
Dometic recommends the driver operate the
switch assembly lever(s) for a period of time without
adjustment until they determine the most suitable
lever distance.
1. With the seat (and wheel position, if equipped with
tilt) adjusted properly, activate the switch from a
normal driving grip.
2. If the lever seems too close or too far from the
steering wheel rim, adjust by carefully bending
the bracket (see Figure 1) slightly in the required
direction to move the lever closer to or farther from
the rim of the steering wheel. Adjust to suit the
driver’s preference.
7 Disposal
M
Place the packaging material in the appropriate
recycling waste bins, whenever possible. Consult
a local recycling center or specialist dealer for
details about how to dispose of the product in
accordance with all applicable national and local
regulations.
