29
EN
Control Parameters
If the system enters sleep mode, the PIN entry will be
required again to re-access the same level. The PIN
entry will also be required again if this level setting is
changed or if the display is AC power cycled.
34
System Menu Screen - Change Pin Submenu
–
Change Pin .
Configures the access PIN. Enter
the current pin first. Factory default is “1234”. If
the PIN is forgotten, it can be restored to 1234
by powering off the control at the circuit breaker,
removing the battery for 60 seconds, reinstalling,
and repowering. This resets the date and time to
the factory default and also resets the PIN to 1234.
No other parameters or saved entries will be lost.
9 .8 Understanding the
Troubleshooting/Commissioning
Screens
This section describes the menu screens available for
troubleshooting and commissioning the system.
See “Troubleshooting” on page 36. for specific
troubleshooting procedures.
See “Commissioning the System” on page 12 for step
by step instructions to commission a unit by testing the
main inputs and outputs. Steps vary depending on the
system. A successful completion will add an entry into
the fault history screen.
35
Troubleshooting/Commissioning Screen
36
Troubleshooting/Commissioning Screen - DX System Status
37
Troubleshooting/Commissioning Screen - CW System Status
1 System Status
. Displays the live readings and status
of all sensors, voltage, frequency, mode status, cycle
fault counts, and other key readings. The screen will
vary based on the system in operation.
Summary of Contents for MCS-CTRL
Page 42: ...42 EN Smart Touch Cabin Control...
