Operating MagicTouch
MT400
EN
20
9.3
Learning or deprogramming the hand-held transmitter
See fig.
g
MagicTouch can be operated using up to 10 hand-held transmitters. If a new hand-held transmitter
is to be learned, all other transmitters will have to be paired
again
.
Proceed as follows for learning a new hand-held transmitter:
To switch to learning mode:
➤
Use a hand-held transmitter to open the vehicle.
➤
Take a seat in the vehicle and leave the door open.
➤
Switch on the ignition.
➤
Press and hold the “comfort” button on a hand-held transmitter already paired.
➤
Switch the ignition off.
➤
Let go of the button.
✓
The status LED and the hazard light flash 10 times, after which they are continually lit.
✓
The system is now in learning mode.
I
Learning the hand-held transmitter
Learn all the hand-held transmitters which you would like to use during this learning phase. This
also applies for the hand-held transmitters which you have already been using!
➤
Press the “Comfort” button on the hand-held transmitter.
✓
The status LED and the hazard lights go out while the value is being saved.
✓
If the status LED and the hazard lights light up continually again after 2 sec., then the hand-held
transmitter has been paired and you can now learn the next one.
I
To exit learning mode:
➤
Switch on the ignition.
Testing the hand-held transmitter
➤
Test the new hand-held transmitter.
If a hand-held transmitter does not function, then they must all be learned again.
NOTE
If you do not press a button within 10 seconds, you will exit the learning mode.
NOTE
Only exit learning mode when you have paired all hand-held transmitters which you
wish to use. Hand-held transmitters which you do not learn during this pairing phase
will be automatically deprogrammed from the system. They can only be used again
once they have been relearned.
MT400--IO--16s.book Seite 20 Donnerstag, 25. August 2016 2:37 14
Summary of Contents for MagicTouch MT400
Page 4: ......
