Connecting MT400
MT400
EN
8
7.2
Connecting MT400 to the central locking system
➤
Connect MagicTouch in accordance with the corresponding circuit diagram (for details, see
table chapter “Keys for the circuit diagrams” on page 8):
•
Vehicles without a servo motor in the driver's door (driver's door cannot be locked and
unlocked from the passenger's door) or with pressure vacuum central locking without electrical
control cable: fig.
7
In these cases, you will require an additional servo motor, type no. ML-11 for the driver's door.
•
Two cables switching from negative to +12 V: fig.
8
•
Two +12 V pulse control cables: fig.
9
•
Two negative pulse control cables: fig.
0
•
One open and negative pulse control cable: fig.
a
•
One +12 V and negative pulse control cable: fig.
b
•
Connection to the central locking system ML-44(22): fig.
c
I
Keys for the circuit diagrams
NOTE
Check whether the indicators flash
once
upon locking with the remote control.
If they flash twice, you will need to reconnect the grey/yellow cable to pin 12 and the
blue/yellow cable to pin 13 of the control unit.
No. in fig.
7
to fig.
c
Designation
1
Control unit for the vehicle's own central locking system
2
Control switch (driver's door) for the original central locking system,
central locking closed
3
Control switch (driver's door) for the original central locking system,
central locking open
MT400--IO--16s.book Seite 8 Donnerstag, 25. August 2016 2:37 14
Summary of Contents for MagicTouch MT400
Page 4: ......
