EN
Configuration of unit software
CoolAir SPX1200I
14
I
➤
Press the
button to save the setting.
✓
The set value is saved and is then applied when the system is restarted.
✓
You are then returned to the menu and can select another menu item by
pressing the
or
button.
7.3
P.02: Unit for temperature display
The system can display the room temperature in °C or °F. This parameter can be
configured:
➤
Switch to configuration mode (chapter “Entering and exiting configuration
mode” on page 13).
✓
The display shows “P.01” and the symbol
flashes.
➤
Press the
or
button to select the menu item P.02.
✓
The display shows “P.02” and the symbol lights up.
➤
Press the
button to change the setting.
✓
The code for the current setting is displayed:
–
0: °C
–
1: °F
➤
Use the
or
button to select the desired temperature unit.
➤
Press the
button to save the setting.
✓
The set value is saved and is then applied when the system is restarted.
✓
You are then returned to the menu and can select another menu item by
pressing the
or
button.
NOTE
The level for the low voltage shut-down should not be set any lower than the
minimum battery voltage required to be able to start the engine under any
conditions.
As a rule that should be no less than 22 V.
63;,,VERRN6HLWH)UHLWDJ6HSWHPEHU
