Dometic Buttner MTBCB10, Installation And Operating Manual

Page: 18 / 148

18 4445103620
Legend
Mounting the battery
control booster
Installation location
A
I
Observe the following instructions when selecting
an installation location:
• Ensure that the mounting surface is solid and
level.
• Observe the distance specifications (fig.
4
,
page 4).
Using the display panel
The display panel can be mounted depending on
the installation position of the battery control
booster.
➤
To rotate and reinsert the display panel in place
proceed as shown in fig.
a
, page 6.
➤
To use the display panel as a remote control pro-
ceed as shown in fig.
b
, page 6.
Connecting the battery
control booster
!
!
A
I
Observe the following instructions when connect-
ing the battery control booster:
• Select the appropriate connection variant.
Legend for fig.
c
, page 7 to fig.
f
, page 10:
Charging curve without temperature
sensor connected
Charging curve with temperature sensor
connected
NOTICE! Damage hazard
Before drilling any holes, ensure that no
electrical cables or other parts of the
vehicle can be damaged by drilling, saw-
ing and filing.
NOTE
The battery control booster can be
installed in any mounting position.
The electrical power supply must be
connected by a qualified electrician who
has demonstrated skill and knowledge
related to the construction and opera-
tion of electrical equipment and installa-
tions and has received safety training to
identify and avoid the hazards involved.
WARNING! Electrocution hazard
Observe the recommended cable cross-
sections, cable lengths and fuse (see
table on page 19).
CAUTION! Fire hazard
Place the fuses near the batteries to pro-
tect the cable from short circuits and pos-
sible burning.
NOTICE! Damage hazard
Do not reverse the polarity.
NOTE
• In the case of two or more batteries,
parallel connection is permissible if the
batteries are of the same type, capacity
and age. Connect the batteries diago-
nally.
• For Dometic Büttner LiFePO4 batter-
ies: To ensure measuring the internal
temperature of the battery use the tem-
perature sensor connector to connect
the probe of the temperature sensor to
the negative terminal of the house bat-
tery.
House battery
Starting battery