Dometic BSC01, Installation And Operating Manual

Page: 11 / 208

CAM 1000 / BSC 01 Using the CAM 1000 / BSC01
EN
11
➤
Connect the control cable of the GPS receiver (blue) with the blue CAM3 control cable of the
monitor. This line is used to switch the monitor on/off.
✓
The system will automatically be activated and deactivated via the GPS signal at approx.
40 km/h.
➤
Connect the control cable of the monitor and the camera for the reverse gear (green) with the
vehicle‘s reverse gear signal.
✓
The camera provides an image and object detection is still active, but the warning sound is
deactivated.
8 Using the CAM1000 / BSC 01
I
8.1 Detection range
The detection range of the CAM1000 / BSC 01 is divided into two zones:
• Visible area : depending on mounting height in operating mode A or B
• Active area : 8 m x 4 m
I
8.2 Test indicator when switching on
See fig.
b
I
The test indicator allows the camera to be correctly aligned with the front of the vehicle. The refer-
ence line (fig.
b
1 ) shall be at least in alignment with the front of the vehicle. The active area
(fig.
b
2 ) is marked as a red area in the video for 6 seconds.
I
NOTE
On the initial start-up the GPS receiver must save the satellite position. This may take up
to 5 minutes.
NOTE
The view of the camera into the detection area must not be obscured by vehicle parts.
Objects may not be detected.
NOTE
The video system switches to standby as soon as the ignition is switched on. The sys-
tem is activated depending on the speed from a speed of less than 40 km/h. The cam-
era image appears.
NOTE
In night mode with ambient lighting below 50 lux, the camera switches to black and
white mode. This is necessary to optimize object detection even in poor lighting con-
ditions.