Dometic 7LA.915.681, Installation And Operating Manual

Page: 12 / 36

EN
Installing the device SMP439-11 (7LA.915.681)
12
• Do not install the device
– In wet or damp environments
– In dusty environments
– In the vicinity of combustible materials
– In areas where there is a danger of explosions.
• The place of installation must be well ventilated. A ventilation system must be
available for installations in small, enclosed spaces.
• The air inlet on both short sides of the device must remain clear.
• For ambient temperatures higher than 40 °C (such as in engine or heating com-
partments, or direct sunlight), the heat from the device under load can lead to
reduced output.
• The device must be installed on a level and sufficiently sturdy surface.
• When installing the device above batteries, ensure that the vent hoses are con-
nected tight and leak-proof to the batteries to avoid damage to the device
caused by escaping corrosive sulfur fumes.
A
5.2 Connecting the device
Connecting the battery
Observe the following instructions when connecting the battery:
!
• Ensure that the battery terminals are clean when connecting them.
• Ensure that the plug connector is fitted securely.
• Select a connection cable with a sufficient cross-section (suitable for 15 A).
• Use both the positive and both the negative connections to connect the battery.
• Lay the cables in accordance with VDE 100 (Germany).
• Use the following cable colors:
–
Red: positive connection
– Black: negative connection
NOTICE!
Before drilling any holes, make sure that no electrical cables or other
parts of the vehicle can be damaged by drilling, sawing and filing.
CAUTION!
• Avoid coming into contact with the battery fluid.
• Batteries with a cell short circuit may not be charged, as explosive
gases may form due to overheating of the battery.