6
11/2018 Subject to technical changes.
domat R560
-
softwarewise
using the ModComTool software, available for free
at
www.domat.cz
. The default address (factory setting) is 1, default
communication parameters are 9600, 8, N, 1. Parity and stopbits can be set
in Modbus register 1005 LSB.
The software address is only active if the hardware addressing switch is set
to 0
.
All changes apply after the module is switched off and on again.
Safety note
The device is designed for monitoring and control of heating, ventilation, and air
conditioning systems. It must not be used for protection of persons against health
risks or death, as a safety element, or in applications where its failure could lead to
physical or property damage or environmental damage. All risks related to device
operation must be considered together with design, installation, and operation of
the entire control system which the device is part of.
