2-7
7. Cut exposed wiring and twisted shield to the lengths indicated below; measured from
end of the outer cable casing.
casing
end of outer
shield - cut to 2.1 inches
blue - cut to 2.4 inches
black - cut to 2.5 inches
shield - to 2.6 inches
white - cut to 2.8 inches
shield - cut to 2.9 inches
black - cut to 3 inches
green - cut to 2 inches
of shield drain wires
Tin last .12 inch
black - cut to 1.6 inches
shield - cut to 1.8 inches
red - cut to 2.2 inches
black - cut to 1.9 inches
8. Strip insulated wires back .12 inch and tin
9. Install 1/16 inch dia clear shrink tubing over each drain wire of the twisted pairs and
heat shrink.
.4" long clear shrink tubing
.5" long clear shrink tubing
.5" long clear shrink tubing
.5" long clear shrink tubing
10. Crimp Molex pins onto wires, 12-PL, using Molex tool HTR-2262-20A, then solder
pins to wires.
11.
Arrange wires in the following order and bend them 90 degrees as shown.
black
shield
white
red
blue black shield
black shield
black greenshield
