5
6
changing operaTing moDes
In the factory, the collar is set to mode Nr 2 (beep sound + light stimulation for sensitive dog).
To change the collar’s mode, proceed in the following way:
When switching on the collar, keep the magnetic key in contact with the red mark located on
the front of the collar (See Diagram 3).
After the beep sound indicating that the collar is on, a series of beep sounds together with
indicator light flashes is emitted (from 1 to 4) indicating the selected mode.
Keep the magnetic key in contact with the red mark to run through modes.
Remove the magnetic key when you have reached the mode you wish. The collar will
memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you
previously selected.
The chart below indicates how your collar operates according to the mode you have selected:
Deactivate:
move the magnetic key towards the collar so that it comes into contact with
the red mark, hold for 1 second (See Diagram 3). Three beep sounds will be emitted and the
indicator light will go from flashing red to permanent red and then off indicating the collar
has been switched off.
To increase the battery life, we recommend you to deactivate the collar if you are not
using it for a long period.
operaTion
After activating the collar,
it remains on standby for 1 minute
to allow you time to attach
the collar on your dog.
It will not activate during this time.
At the first bark, a beep sound is emitted. If another bark is detected within 30 seconds,
another beep sound is emitted together with a static stimulation (light, progressive or strong
stimulation according to the selected operating mode). Inhibition of any further stimulation is
dependant on the absence of any barking within the next 30 seconds.
If your dog stops barking during 30 seconds, at the next bark, the collar will start its
operating cycle from the beginning (beep sounds only).
The stimulation function can be inhibited selecting operating mode Nr 1. In this case, only
beep sounds will be emitted.
After being activated 5 times in quick succession, the collar will automatically go into
safety mode for 2 minutes before restarting itself normally.
1
Nr 1
Beep sounds only
2
Nr 2
Beep sound + light stimulation (sensitive dog)
3
Nr 3
Beep sound + progressive stimulation
4
Nr 4
Beep sound + strong stimulation (difficult dog)
NUmbEr Of bEEP sOUNDs
TOGEThEr wITh INDIcATOr
lIGhT flAshEs EmITTED whEN
swITchING mODE
mODE
OPErATION
seTTing The barking
DeTecTion sensiTiviTy
Your dog’s barking is detected by one of the
contact points which sense the vibrations of
his vocal cords (See Diagram 1).
Setting the barking detection sensitivity
is a very important preliminary operation.
In fact, this setting determines the correct
operation of the product.
It ensures detection of any barking but helps
avoid unnecessary detection. The detection
must therefore be sufficiently sensitive but
not overly sensitive.
In the factory, detection sensitivity is set on
level 5 (medium sensitivity).
To adapt the detection sensitivity to the
barking strength of your dog, turn the
button located on the front of the collar
according to the sensitivity you wish (See
Diagram 1).
cAUTION:
the adjustment button has a stop
for the minimum sensitivity (0) and for the
maximum sensitivity (10).
