Dodge Charger SRT 392 2017, Operating Information Manual

Page: 227 / 576

HAZARD WARNING FLASHERS
The Hazard Warning flasher switch is located on
the instrument panel, below the radio.
Push the switch to turn on the Hazard
Warning flasher. When the switch is
activated, all directional turn signals
will flash on and off to warn oncoming traffic of
an emergency. Push the switch a second time to
turn off the Hazard Warning flashers.
This is an emergency warning system and it
should not be used when the vehicle is in
motion. Use it when your vehicle is disabled and
it is creating a safety hazard for other motorists.
When you must leave the vehicle to seek assis-
tance, the Hazard Warning flashers will continue
to operate even though the ignition is placed in
the OFF position.
NOTE:
With extended use, the Hazard Warning
flashers may wear down your battery.
IF YOUR ENGINE OVERHEATS
In any of the following situations, you can re-
duce the potential for overheating by taking the
appropriate action.
•
On the highways — slow down.
•
In city traffic — while stopped, place the
transmission in NEUTRAL, but do not in-
crease the engine idle speed.
NOTE:
There are steps that you can take to slow
down an impending overheat condition:
•
If your air conditioner (A/C) is on, turn it
off. The A/C system adds heat to the
engine cooling system and turning the
A/C off can help remove this heat.
•
You can also turn the temperature control
to maximum heat, the mode control to
floor and the blower control to high. This
allows the heater core to act as a supple-
ment to the radiator and aids in removing
heat from the engine cooling system.
WARNING!
You or others can be badly burned by hot
engine coolant (antifreeze) or steam from
your radiator. If you see or hear steam com-
ing from under the hood, do not open the
hood until the radiator has had time to cool.
Never try to open a cooling system pressure
cap when the radiator or coolant bottle is hot.
CAUTION!
Driving with a hot cooling system could dam-
age your vehicle. If the temperature gauge
reads 240°F (116°C) or greater pull over and
stop the vehicle. Idle the vehicle with the air
(Continued)
CAUTION! (Continued)
conditioner turned off until the pointer drops
back into the normal range 200–230°F (93–
110°C). If the pointer remains at 240°F (116°C)
or greater and you hear a chime, turn the
engine off immediately and call for service.
WHEEL AND TIRE TORQUE
SPECIFICATIONS
Proper lug nut/bolt torque is very important to
ensure that the wheel is properly mounted to the
vehicle. Any time a wheel has been removed
and reinstalled on the vehicle, the lug nuts/bolts
should be torqued using a properly calibrated
torque wrench.
Torque Specifications
Lug Nut/Bolt
Torque
**Lug
Nut/Bolt
Size
Lug Nut/
Bolt
Socket
Size
111 Ft-Lbs
(150 N·m)
M14 x
1.50
22 mm
**Use only your authorized dealer recom-
mended lug nuts/bolts and clean or remove any
dirt or oil before tightening.
Inspect the wheel mounting surface prior to
mounting the tire and remove any corrosion or
loose particles.
224