Dodge Charger SRT 392 2017, Operating Information Manual, Page: 257 / 576

When cleaning the rear view mirror, spray
cleaner on the towel or cloth that you are using.
Do not spray cleaner directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this
vehicle are molded in clear plastic. When clean-
ing the lenses, care must be taken to avoid
scratching the plastic.
1. Clean with a wet soft cloth. A mild soap
solution may be used, but do not use high
alcohol content or abrasive cleaners. If soap
is used, wipe clean with a clean damp cloth.
2. Dry with a soft cloth.
Seat Belt Maintenance
Do not bleach, dye, or clean the belts with
chemical solvents or abrasive cleaners. This will
weaken the fabric. Sun damage can also
weaken the fabric.
If the belts need cleaning, use Mopar Total
Clean, a mild soap solution, or lukewarm water.
Do not remove the belts from the vehicle to
wash them. Dry with a soft cloth.
Replace the belts if they appear frayed or worn
or if the buckles do not work properly.
WARNING!
A frayed or torn belt could rip apart in a
collision and leave you with no protection.
(Continued)
WARNING! (Continued)
Inspect the belt system periodically, checking
for cuts, frays, or loose parts. Damaged parts
must be replaced immediately. Do not disas-
semble or modify the system. Seat belt as-
semblies must be replaced after a collision if
they have been damaged (i.e., bent retractor,
torn webbing, etc.).
Cleaning The Center Console Cupholders
Clean with a damp cloth or towel using a mild
detergent with the cupholder in the center con-
sole.
NOTE:
The cupholder cannot be removed.
FUSES
WARNING!
•
When replacing a blown fuse, always use
an appropriate replacement fuse with the
same amp rating as the original fuse.
Never replace a fuse with another fuse of
higher amp rating. Never replace a blown
fuse with metal wires or any other material.
Failure to use proper fuses may result in
serious personal injury, fire and/or property
damage.
(Continued)
WARNING! (Continued)
•
Before replacing a fuse, make sure that the
ignition is off and that all the other services
are switched off and/or disengaged.
•
If the replaced fuse blows again, contact an
authorized dealer.
•
If a general protection fuse for safety sys-
tems (air bag system, braking system),
power unit systems (engine system, gear-
box system) or steering system blows,
contact an authorized dealer.
Front Power Distribution Center
(Fuses)
The Front Power Distribution Center is located
in the engine compartment. This module con-
tains fuses and relays. Fuse cavity location and
descriptions are printed on the inside of the
power distribution center cover.
Front Power Distribution Center
254