Dodge Charger SRT 392 2017, Operating Information Manual

Page: 114 / 576

4. Fuel Gauge
•
The pointer shows the level of fuel in the
fuel tank when the Keyless Push Button
Ignition is in the ON/RUN position.
•
The fuel pump symbol points to the
side of the vehicle where the fuel door is
located.
5. Temperature Gauge
•
The temperature gauge shows engine
coolant temperature. Any reading within
the normal range indicates that the engine
cooling system is operating satisfactorily.
•
The gauge pointer will likely indicate a
higher temperature when driving in hot
weather, up mountain grades, or when
towing a trailer. It should not be allowed to
exceed the upper limits of the normal op-
erating range.
WARNING!
A hot engine cooling system is dangerous.
You or others could be badly burned by
steam or boiling coolant. You may want to call
an authorized dealer for service if your ve-
hicle overheats. If you decide to look under
the hood yourself, see “Maintaining Your
Vehicle”. Follow the warnings under the Cool-
ing System Pressure Cap paragraph.
CAUTION!
Driving with a hot engine cooling system
could damage your vehicle. If the tempera-
ture gauge reads “H” pull over and stop the
vehicle. Idle the vehicle with the air condi-
tioner turned off until the pointer drops back
into the normal range. If the pointer remains
on the “H”, turn the engine off immediately
and call an authorized dealer for service.
WARNING AND INDICATOR
LIGHTS
The warning/indicator lights switch on in the
instrument panel together with a dedicated mes-
sage and/or acoustic signal when applicable.
These indications are indicative and precaution-
ary and as such must not be considered as
exhaustive and/or alternative to the information
contained in the Owner’s Manual, which you are
advised to read carefully in all cases. Always
refer to the information in this chapter in the
event of a failure indication.
All active telltales will display first if applicable.
The system check menu may appear different
based upon equipment options and current ve-
hicle status. Some telltales are optional and may
not appear.
Warning/Indicator Bulb Check
With all doors closed, place the ignition in the
ON position without starting the engine. The
following lights will briefly come on and then go
off to complete the warning/indicator bulb check.
If any warning/indicator light fails to come on, or
go off during the bulb check cycle it may indicate
a potential concern. Contact your authorized
dealer as soon as possible.
NOTE:
The bulb check procedure as identified above
will also be supported during startup.
111