2. Press the “Launch RPM Set-Up” button on
the touchscreen. This screen will allow you
to adjust your launch RPM for optimum
launch/traction. To adjust the Launch RPM,
press and drag the slider bar or press the
arrows on the touchscreen to adjust the
holding RPM. Press the back arrow button
when finished. The setting will be saved.
NOTE:
The default for launch control is 3000 RPM.
Optimal launch RPM will depend on the
engine and tires on the vehicle, as well as
road and weather conditions. Not all RPM
settings will be usable in all configurations
and scenarios. If requested launch RPM is
not attainable in a given scenario, the en-
gine will provide the maximum amount of
torque possible to get as close as possible
to the requested RPM.
3. Press the “Activate Launch Mode” button on
the touchscreen.
4. Ensure the vehicle is not moving and the
steering wheel is pointing straight.
5. Fully depress the clutch pedal and verify the
vehicle is in first gear.
6. While holding the clutch depressed, rapidly
apply the accelerator pedal to wide open
throttle. The engine speed will hold at the
RPM that was set in the “Launch RPM
Set-up” screen.
NOTE:
Messages will appear in the Driver Informa-
tion Display (DID) to inform the driver if one
or more of the above conditions have not
been met.
7. When conditions four through six have been
met, the DID will read “Launch Ready Re-
lease Clutch.” Release the clutch quickly
and continue to hold wide open throttle to
launch. Execute shifts as described in the
section “Manual Transmission – Shifting.”
8. Keep the vehicle pointed straight. Launch
control will be active until the vehicle
reaches 62 MPH (100 km/h).
Launch Control will abort before launch comple-
tion and display “Launch Aborted” in the DID for
any the following conditions:
•
The brake is applied during launch.
•
The ESC system detects that the vehicle is
no longer moving in a straight line.
•
The “ESC OFF” button is pressed to change
the ESC system to another mode if Launch
Control is enabled.
NOTE:
Launch mode is not available within the first
500 miles of engine break-in.
CAUTION!
Do not attempt to shift when the drive wheels
are spinning and do not have traction. Dam-
age to the transmission may occur.
181
Summary of Contents for 2016 Challenger
