2. If desired, press the “Launch RPM Set-Up”
button on the touchscreen. This screen will
allow you to adjust your launch RPM for
optimum launch/traction. To adjust the
Launch RPM, press and drag the slider bar,
or press the arrows on the touchscreen, to
adjust the holding RPM. Press the back
arrow button on the touchscreen when fin-
ished. The setting will be saved.
NOTE:
The default RPM for launch control is a
preset factory value. Optimal launch RPM
will depend on the engine and tires on the
vehicle, as well as the road and weather
conditions. Not all RPM settings will be
usable in all configurations and scenarios. If
requested launch RPM is not attainable in a
given scenario, the engine will provide the
maximum amount of torque possible to get
as close as possible to the requested RPM.
3. Press the “Activate Launch Mode” button on
the touchscreen.
4. Ensure the vehicle is not moving and the
steering wheel is pointing straight.
5. Hold the brake pedal and verify the vehicle is
in “Drive.”
6. While holding the brake, rapidly apply the
accelerator pedal to wide open throttle. The
engine speed will hold at the RPM that was
set in the “Launch RPM Set-up” screen.
NOTE:
Messages will appear in the Driver Informa-
tion Display (DID) to inform the driver if one
or more of the above conditions have not
been met.
7. When conditions four through six have been
met, the DID will read “Launch Ready Re-
lease Brake.” Release the brake and con-
tinue to hold wide open throttle to launch.
8. Keep the vehicle pointed straight. Launch
Control will be active until the vehicle
reaches 62 MPH (100 km/h).
Launch Control will abort before launch comple-
tion and display “Launch Aborted” in the DID for
any the following conditions:
•
The accelerator pedal is released during
launch.
•
The ESC system detects that the vehicle is
no longer moving in a straight line.
•
The “ESC OFF” button is pressed to change
the system to another mode if Launch Con-
trol is enabled.
NOTE:
Launch mode is not available within the first
500 miles of engine break-in.
Manual Transmission — If Equipped
Launch Control is only available when the fol-
lowing procedure is followed:
1. Press the “Apps” button on the touchscreen,
select Performance Control, and press the
“Launch Control” button on the touchscreen
or push the Super Track Pak button on the
center stack switch bank.
180
Summary of Contents for 2016 Challenger
