Diagnostics — If Equipped
Push and release the UP
or DOWN
ar-
row button until the diagnostic Menu is selected.
Then, the Driver is able to view engine and
emission vehicle faults.
•
Push OK to have the most recent fault code
sent.
•
There is a delay when the next diagnostic
code is requested during which the following
message is displayed:
•
“Checking System for Diagnostic Codes.”
•
Driver must push the OK button again to see
the next Pcode otherwise current message
remains displayed.
•
Driver exits when they cycle to another sub-
menu (up or down).
•
Faults are displayed from newest to the
oldest.
•
If the menu is exited before the end of codes
is reached - when the driver re-enters the list
will be restarted from the beginning.
•
When no codes are present or the last code
is reached = (P0000) and this message is
displayed:
•
“No Further or End of Diagnostic Codes.”
Battery Saver On/Battery Saver
Mode Message — Electrical Load
Reduction Actions — If Equipped
This vehicle is equipped with an Intelligent
Battery Sensor (IBS) to perform additional
monitoring of the electrical system and status of
the vehicle battery.
In cases when the IBS detects charging system
failure, or the vehicle battery conditions are
deteriorating, electrical load reduction actions
will take place to extend the driving time and
distance of the vehicle. This is done by reducing
power to or turning off non-essential electrical
loads.
Load reduction is only active when the engine is
running. It will display a message if there is a
risk of battery depletion to the point where the
vehicle may stall due to lack of electrical supply,
or will not restart after the current drive cycle.
When load reduction is activated, the message
“Battery Saver On” or “Battery Saver Mode” will
appear in the Electronic Vehicle Information
Center (EVIC) or Driver Information Display
(DID).
These messages indicate the vehicle battery
has a low state of charge and continues to lose
electrical charge at a rate that the charging
system cannot sustain.
NOTE:
•
The charging system is independent from
load reduction. The charging system per-
forms a diagnostic on the charging sys-
tem continuously.
•
If the Battery Charge Warning Light is on
it may indicate a problem with the charg-
ing system. Refer to “Battery Charge
Warning Light” in “Understanding Your
Instrument Panel” for further information.
154
Summary of Contents for 2016 Challenger
