Dodge 2016 Challenger, Operating Information Manual

Page: 163 / 737

•
ParkSense
The ParkSense system will scan for objects
behind the vehicle when the transmission gear
selector is in REVERSE and the vehicle speed
is less than 11 mph (18 km/h). It will provide an
alert (audible and/or visual) to indicate the prox-
imity to other objects. The system can be en-
abled with Sound Only, or Sound and Display.
To change the ParkSense status, press and
release the “Sound Only” or “Sound and Dis-
play” button. Refer to “ParkSense” in “Under-
standing The Features Of Your Vehicle” for
system function and operating information.
•
Rear ParkSense Chime Volume
The Rear ParkSense Chime Volume settings
can be selected from the DID or Uconnect
System — if equipped. The chime volume set-
tings include LOW, MEDIUM, and HIGH. The
factory default volume setting is MEDIUM. To
make
your selection, press the “Rear
ParkSense Volume” button on the touchscreen,
then select from “Low,” “Med,” or “High.”
ParkSense will retain its last known configura-
tion state through ignition cycles.
•
Blind Spot Alert
When this feature is selected, the Blind Spot
Alert feature Provides alerts, visual and/or au-
dible, to indicate objects in your blind spot. The
Blind Spot Alert feature can be activated in
Lights mode. When this mode is selected, the
Blind Spot Monitor (BSM) system is activated
and will only show a visual alert in the exterior
mirrors. When Lights & Chime mode is acti-
vated, the Blind Spot Monitor (BSM) will show a
visual alert in the exterior mirrors as well as an
audible alert when the turn signal is on. When
Off is selected, the Blind Spot Monitor (BSM)
system is deactivated. To change the Blind Spot
Alert status, press the “Off,” “Lights,” or “Lights
& Chime” button on the touchscreen.
NOTE:
If your vehicle has experienced any damage
in the area where the sensor is located, even
if the fascia is not damaged, the sensor may
have become misaligned. Take your vehicle
to an authorized dealer to verify sensor
alignment. Having a sensor that is mis-
aligned will result in the BSM not operating
to specification.
•
ParkView Backup Camera Active Guide-
lines
Your vehicle may be equipped with the
ParkView Rear Back Up Camera Active Guide-
lines that allows you to see active guidelines
over the ParkView Back up camera display
whenever the gear selector is put into RE-
VERSE. The image will be displayed on the
radio touchscreen display along with a caution
note to “check entire surroundings” across the
top of the screen. After five seconds, this note
will disappear. To enable or disable, press the
“ParkView Backup Camera Active Guidelines”
button on the touchscreen, and select “On” or
“Off.”
•
ParkView Backup Camera Delay
When the vehicle is shifted out of REVERSE
(with camera delay turned OFF), the rear cam-
era mode is exited and the navigation or audio
screen appears again. When the vehicle is
shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic
grid lines will be displayed for up to 10 seconds
after shifting out of “REVERSE” unless the
forward
vehicle speed exceeds 8 mph
160