Doco SRR-70, Installation Manual

Page: 38 / 40

38
11.1 Operator settings
Adjustment to the operator should be carried out in accordance with the operator manufacturers manual.
Please note that our hardware kits have been CE approved for use with the operators specified in our ITT report and enclosure B. Should a differ
-
ent operator be chosen, then the installer must carry out a peak force analysis in accordance with EN 12445 and EN 12453.
12 Disassembly
The door should be disassembled in the reverse sequence to the assembly manual.
12.1 Disposal
All parts of this garage door can be easily disposed of.
Please consult your local authorities on this matter
13 Maintenance
In accordance with EU standards, sectional overhead doors should be checked, from the first time of use, based on the indicated service by the
installer.
This inspection service has to be recorded written.
This inspection service should be carried out by an approved installer cq company.
Directly after installing:
1) lubricate the tracks (advice: PTFE spray) By Installer
2) lubricate bearings, and rollers (advice: PTFE spray) By Installer
3) lubricate pins of the hinges from intermediate- and side-hinges (advice: PTFE spray) By Installer
4) lubricate sealing rubbers (advice: special rubber grease or talcum powder By Installer
After 3 months:
1) Re-tensioning springs ( relaxation springs) By Installer
2) visual inspection By Installer
Every 6 months or every 750 door cycles:
1) remove debris from the door and surroundings By: user
2.lubricate the tracks (advice: PTFE spray) By: user
3.lubricate bearings, shafts and rollers (advice PTFE spray) By: user
4.lubricate pins of the hinges from intermediate- and side-hinges (advice: PTFE spray) By: user
5.lubricate sealing rubbers (advice: special rubber grease or talcum powder) By: user
6.clean the panels (advice: shampoo for car cleaning with water), do not use aggressive detergents By: user
7.wax the panels (advice: car wax) By: user
Every 12 months or every 1500 door cycles :
1) check the cables, the end connections from the cable drums and bottom brackets on wear or damages By Installer
2.check the spring break devices in accordance with separate manual By Installer
3.check the balance of the door By Installer
4.check the pulley (if present) for wear or damages By Installer
5.check the rollers for wear and damages By Installer
6.check the closing forces of the main closing edge By Installer
7.check the suspension from the horizontal track to the ceiling By Installer
8.check the weather strips for wear or damages By Installer
9.check the bottom seal for wear or damages By Installer
10.check the rubber seals on the top panel for wear of damage By Installer
11.check the shaft coupler (if present) By Installer
12.lubricate the torsion springs By Installer