background image

INSTALLATION GUIDE

Figure 2

Step One

Start by bolting both the left and right side roller door columns to the 
respective portal frame columns. Secure the header beam to each 
roller door column using two header beam brackets. Use two plain 

10x16mm self tapping screws in each flange of the header beam 

brackets. The bottom face of the header beam should measure 

300mm from the top of the top girt (refer to Figure 1) to allow a fixing 

point for the 300mm Superdek® header sheets (refer to Figure 3).

Complete the steps below while building the wall panels on the ground in conjunction with Figures 4-8 of the Gable Homeshed 
Framework Installation Guide. Roller door column flashings can be installed when the completed wall frames are standing.

Step Two

Position the roller door column flashings over the roller door 

columns, and in corner applications over the ends of the gable end 
sheets. Fasten the two roller door column flashings (corner or wall 
depending on application) to your roller door columns using coloured 

10x16mm self tapping screws at 600mm centres. In applications 

where the roller door column wall flashings are used, the flashing 
will need to be notched as shown in Figure 2. Rivet the roller door 
header flashing into place on the header beam using 3.2mm rivets at 

600mm centres so that both bottom faces are flush (Refer to Figure 2).

Single Roller Door

TYPE 9

300mm

to the
top of

the girt

LHS 

Roller Door

Column

Column

Header Beam
Bracket

RHS 

Roller Door

Column

Column

Header

Beam

12x30mm

Flanged Purlin Bolts

10x16mm

Self Tapping Screws

Figure 1

Roller Door

Header

Flashing

Bottom

faces flush

Roller Door

Column Wall

Flashing

(adjacent wall

applications)

Roller Door

Column Corner

(in corner

applications)

10x16mm

Self Tapping

Screws

3.2mm

Rivets

Reviews: