Install the TOGGLER® brand SNAPTOGGLE® anchor
*
Secure Surface Mount to Dock
Secure Dock Surface Mount with
washers and ¼ - 20 screws pro Use
Hold metal channel
Hold ends of straps between
Snap straps at wall
7/16 wrench or socket.
flat alongside plastic
thumb and forefinger and pull
by pushing side to
straps and slide
toward you until channel rests
side, snapping off
channel through hole.
flush behind decking. Slide
straps level with
Minimum clearance
plastic cap along straps with
flange of cap.
Under dock: 1-7/8"
other hand until flange of cap
is flush with decking
.
Completed Assemblies
Dockside Operation Model – DS100
Waterside Operation Model – WS100
Series 100 – Bolt On Dock Mount Installation
Note:
If you have a wooden structure under your
decking at the 2 ¼ inch location, you should
use a lag bolt.
See the Dock Configuration Guide Page 12
At the install position align Dock Mount as shown above
Drill ½ diameter holes through Dock Decking Surface
With a pencil scribe the hole locations (2) on dock surface
Ensure there are not any electrical or structural
While the dock mount is positioned as shown above.
components near the hole you are drilling. Also
Note: the 2
nd
mount is positioned
check 26 to 32 inches away at the 2
nd
mount location.
Dockside unit - 32 inch apart Waterside unit
–
26 ½ inches apart
Dock Surface Mount
Dock Mount is
Your Dock
positioned against
Side Rail
the side of your dock
1 - Select a position on your dock where you choose to mount your Kayak Storage Rack.
Ensure there are not any electrical or structural components in the area.
2 - The Docksider should be mounted on 1 section of your dock.
3 - Make sure the wood on your dock is solid (not cracked or rotting) at the installation position.
4 - Ensure there are no obstructions above or below your dock.
5 - Place one Dock Mount on your Dock and position as shown below
6 - Install
Note:
- Use a ½ in. diameter drill for hardware provided
- Use a 1/8 in. diameter drill for pilot for ¼ lag bolts
- Use a ¼ in. diameter drill for ¼ machine screws and nuts
* "U.S. Patent no. 6,161,999
and foreign counterparts
thereof. Other patents
pending. TOGGLER &
typeface and SNAPTOGGLE
are worldwide registered
trademarks of Mechanical
Plastics Corp."
Page 6 of 14
