Adjust the Clamp On Mount to Fit Your Dock
–
Typical Dock Decking Configurations
Check the Dimensions on your Dock
Measure the width of your Side Rail
Decking Flush with Side Rail
Decking on Top of Side Rail
Side Rail Setback from Edge of Dock
The clamp on mount can be adjusted to accommodate the dimensions indicated.
If your dock has dimensions thar do not fall within the dimensions specified, give us a call (585-734-7374) or email
us at
. In many cases, we can modify the mount to your needs.
Set the Dock Clamp to the proper dimension.
Dock Clamp
Measure the distance from the edge of the dock to the back side of the side rail (red arrows).
Back off the hand knob such that the length of the threaded rod between the front of the dock clamp and the
inside of the clamp on mount is the same as what you had measured.
15 ¼ inches
12 ½ inches
Typically, 1 ½ inches
No more than 5 ½ inches
No more than 5 ½ inches
Decking Thickness
1 to 1 ½ inches
No Less than 2 ½ inches.
No Greater than 7 ½ inches
No under Decking Supports
in this area
Note: The adjustment rod
will probably come out of
the hole in the mount.
Back off
wing nut
Seat Adjustment
rod in hole in
mount
Tighten right
wing nut against
Dock Clamp then
the left wing nut
Page 7 of 13
