Install the Clamp on Mounts on your Dock
Note:
The Dockside Model: Spacing between mounts is 32 inches (center to center)
The Waterside Model: Spacing between Mounts is 26 ½ inches (center to center).
The Mount as set
Back off hand knob
Rotate Dock Clamp
so adjustment rod
To a horizontal
Is out of its hole in
position
the clamp
Position the mount as shown
Lift up, then in
Rotate Dock Clamp vertical,
then seat adj. rod in hole and
tighten Hand Knob
Your ready to install the second mount., follow the steps above.
1 - Select a position on your dock where you choose to mount your Kayak Storage Rack.
Ensure there are not any electrical or structural components in the area.
2 - The Docksider should be mounted on 1 section of your dock.
3 - Make sure the wood on your dock is solid (not cracked or rotting) at the installation position.
4 - Ensure there are no obstructions above or below your dock.
5 - Place one Dock Mount on your Dock and position as shown below.
Dockside Unit - 32 inches
Waterside Unit
–
26 ½ inches
Edge of Dock
Align the 2nd Dock Mount per the diagram above and install as mounting the first mount
Tighten the hand knob (
Do Not over tighten
), then recheck the distance between mounts. Adjust as
necessary.
Page 8 of 13
