19
TYPICAL OPERATION PROCEDURES
(Continued....)
Automatic Operation
1.
Follow steps 1 through 8 of the
"Manual Operation"
section.
2.
Go to the
SETUP
Screen and select either the "JOB
MODE SINGLE JOB" or "JOB MODE RUN LIST".
•
If the "SINGLE JOB" mode is selected, go to the
VIEW
Screen and enter the cut length and quantity
of parts desired.
•
If the "RUN LIST" mode is selected, go to the
JOBS
Screen and start entering the cut length and quantity
of parts for each job to be done using the pop-up
keypad. Make sure to press "RESET ALL DONES"
to clear the "DONE" column.
3.
Clamp both front and index vises.
Both vises must
be clamped for the automatic cycle to operate.
4.
Press the "BAND/CYCLE START" key. As the saw
band drive comes up to speed, the index vise jaws
open, the indexer moves to a full forward position
to reset, and then moves back to the set index cut
length and clamps. The saw head will descend
when the operator adjusts the
Feed Rate
control
counterclockwise
to begin saw head feed.
5.
After the first cut has been completed:
(a)
The saw
head will raise just above the material;
(b)
The fixed
vise will open and the index vise moves the material
forward for the next cut;
(c)
When the forward stop
is reached, the fixed vise clamps, the indexer moves
back to the set index cut length and clamps and the
saw head lowers to make the next cut.
6.
The operator may adjust band speed, coolant flow,
feed rate, and/or feed force at any time during the
sawing process.
7.
There is several ways in which the operator may
interrupt the sawing cycle:
•
Pressing the "SAW HEAD UP" key. The saw head
will move to the maximum up position, the saw band
will stop and the saw will go to manual mode.
•
Pressing the "BAND/CYCLE STOP" or the "AUTO
MODE" keys. The saw band will stop and puts the
saw into manual mode.
•
To continue the auto cycle, the operator presses
the "BAND/CYCLE START" key. The saw band will
start, come up to speed and then the saw head will
descend from where it was paused.
8.
The automatic cycle will continue to cycle until all
programmed jobs have been completed.
9.
When the number of cuts has been reached, the
saw head will move to the head clear position and
the band drive motor will shut off.
DO NOT remove any cut-off pieces until they
are away from the saw band or the saw band
has stopped completely.
For future reference, keep a record of band
speed, feed rate and coolant application
settings for successful jobs.
Summary of Contents for 500SNC
