21
2.
When using the work slides, replace the worktable's
center plate with a center plate with an attached
block to support stock at the sawing point.
Heavy Work Slides.
WORKHOLDING JAWS
1.
This option is used for off-hand and contour
sawing. By looping a power feed chain around the
workholding jaws, the operator can use the cable
pulley system to guide stock along the contour
layout lines.
Be sure to use the correct saw band wdth
when cuttng a radus.
Workholding Jaws.
AIR-OPERATED POWER FEED
Ths opton requres shop ar: 20 ps (1.38
bar) minimum; 100 psi (7 bars) maximum. It
has been tested at 70 ps (4.8 bars) pressure
durng factory nspecton.
1.
Air power feed provides steady feeding pressure
and allows the operator to use both hands to guide
the stockpiece.
2.
This system has:
(a)
A pressure-regulating valve
and gauge located slightly below the left worktable
surface;
(b)
A pulley and cable system attached by
an adjustable bracket to the rear worktable edge
and to an air cylinder mounted to the machine
base.
3.
Operation procedures are as follows:
•
Adjust the pulley and cable system for stock width.
This is done by:
(a)
Loosening the two (2) knobs
located under the rear mounting bracket;
(b)
Removing any slack in the workholding chain.
Chain and Pulley System.
•
Set the desired feed force with the regulating valve
knob. Turn the knob
clockwse
to increase feed
force,
counterclockwse
to decrease it. Refer to
the gauge for pressure readings.
Pressure Valve and Gauge.
•
Place stock between the workholding jaws and
remove any slack in the cable. Next:
(a)
Start the
machine;
(b)
Begin the cut by pushing down slightly
on the foot pedal.
•
Feed force can be increased while sawing by
applying additional pressure on the foot pedal.
When the sawing is finished, remove your foot from
the pedal to relax feed force.
A specal ol-mst lubrcator s ncluded wth
ths opton.
HEAVY WORK SLIDES (Continued....)
Summary of Contents for 3613-V5
