DoAll 3613-V5, Instruction Manual

Page: 12 / 32

8
ELECTRICAL CONTROLS
1. Foot Swtch. Does not apply to this machine.
• Laser (Optonal). This control turns the optional
laser line generator "OFF" and "ON".
2. Hydraulc. Not applicable when plugged.
3. Mst Lube (Optonal). This switch turns the optional
band mist lubricator "OFF" and "ON".
4. Band Start/Stop. Push this upper green portion
of the button to start the band drive motor. Push
the lower red portion of the button to stop the band
drive motor.
Typical Electrical Control Box.
5. All Stop (Emergency Stop). Push this red
mushroom head button to stop all functions of the
machine. To resume operation, the button must be
reset by rotating the button head clockwse until
the head pops up.
Other Controls
1. Dsconnect Swtch. This switch, located on the
electrical control box enclosure, turns the supplied
incoming power to the machine "on" and "off".
2. Worklght (Optonal). A switch on the worklight
turns the light "OFF" and "ON".
3. Controls for the optional DBW-15 Buttwelder are
described in a seperate instruction manual.
BAND SPEED CONTROL
1. The band speed control are located on the electrical
box mounted on the front of the machine.
2. Only the "high" speed set of numbers on the
escutcheon are used for your band speed range.
The "high" band speed range is 550 to 5500 fpm
(170 to 1675 m/min).
3. Variable speed is changed by turning the Band
Speed knob. Turn the control clockwse to
"increase" the band speed, counterclockwse to
"decrease" it.
4. During machine operation, keep the following band
speed precautions in mind:
Adjust the band speed only whle the machne
s runnng.
Always turn the speed speed to ts lowest
speed before stoppng the machne.
Always allow the saw band to stop completely
before openng any bandwheel door.
SAW BAND PREPARATION
Saw Band Selecton
1. The machine is equipped with an Imperial Bi-Metal
Super Silencer saw band that is 154 inches (3911.6
mm) long. It will accept saw band widths from 1/16
to one (1) inch (1.6 to 25.4 mm).
2. Standard equipment includes:
• One (1) set of high-speed, insert-type saw guide
blocks for saw bands from 1/16 to 1/2 inch (1.6 to
12.7 mm) wide.
• One (1) set of steel saw guide inserts for saw bands
1/4 to 1/2 inch (6.3 to 12.7 mm) wide.
Informaton about all DoALL saw bands can be
obtaned from a DoALL sales representatve.
Insert-Type Saw Gude Adjustment
These nstructons apply to both the upper
and lower nsert-type saw gude blocks.
Select the saw guide blocks and inserts marked for
the width of the saw band to be used. Then: (a)
Place the left insert in the left milled slot; (b) Tighten
the insert screw slightly so that the insert will slide
in the slot, yet still hold its correct position when
released.