DMX ProFusion XS, User Manual

Page: 9 / 36

3
Connecting ProFusion XS to Your Amplification equipment
Always connect audio cables prior to powering on your ProFusion XS.
Turn off your amplification equipment and turn the volume completely down before installing your •
ProFusion XS.
Your ProFusion XS should not be plugged into the AC outlet found on the rear of some audio amplifica-
•
tion equipment due to potential grounding issues. Only plug your ProFusion XS into properly
grounded electrical outlets.
To avoid being inadvertently powered off, never plug your ProFusion XS into a switched outlet.
•
Connecting your ProFusion XS to your amplification equipment:
STeP 1 Connect one end of the RCA audio cable with the white plugs into the white RCA jack labeled Zone 1
on the rear panel of your ProFusion XS. Connect the other end of the RCA cable into the correspond-
ing input of your amplification equipment.
Note: If your ProFusion XS is configured for only one zone, the audio for that zone will output from
both the Zone 1 and Zone 2 RCA jacks. Connect one end of the RCA audio cable with the red plugs
into the red RCA jack labeled “Zone 2” on the rear panel of your ProFusion XS. Connect the other
end of the RCA cable into the corresponding input of your amplification equipment.
STeP 2
If your ProFusion XS has been configured for a second zone of audio, connect the red RCA plug of the
audio cable into the RCA jack labeled Zone 2 (red jack) on the rear panel of your ProFusion XS. Connect
the other end of the RCA cable (red plug) into the corresponding input of your amplification
equipment.
STeP 3
If your ProFusion XS has been configured for a third zone of audio, repeat step 1. If your ProFusion XS
has been configured for a third and forth zone of audio, repeat steps 1 and 2.
Note: If your ProFusion XS is configured for three zones, the audio output for Zone 3 will also output
the Zone 4 RCA jack. Connect one end of the RCA audio cable with the red plugs into the red RCA
jack labeled “Zone 4” on the rear panel of your ProFusion XS. Connect the other end of the RCA
cable into the corresponding input of your amplification equipment.
Connecting ProFusion XS to Your network
Connecting your ProFusion XS to your company’s network:
STeP 1 Connect one end of a CAT5 Ethernet cable to the Ethernet port located on the rear panel of your Pro-
Fusion XS.
STeP 2 Connect the other end of the CAT5 Ethernet cable to your network equipment (router, hub, or switch).
it is highly recommended that a connectivity test is performed after changing any network settings. See Testing the
Network Settings (p. 19) for instructions.