DMQ QH5 U, User Manual

Page: 19 / 77

5 Chapter 1
When the UCI probe is connected to the QH5 U a
message is displayed indicating that the probe has
been recognized. At this time do not try to measure
as the unit will briefly auto-calibrate and in order
for the unit calibration to proceed normally the UCI
probe
needs to be “left alone”.
Figure 1.5: Message indicating probe has been connected
This section briefly explains all of the basic UCI probe components and
their intended use.
Figure 1.6: UCI probe components
1. Area where force is applied
2. Cable connector for cable that goes to the QH5 U
3. UCI probe body