DMP Electronics 9000 Series, Installation And Programming Manual

Page: 11 / 48

Digital Monitoring Products, Inc | 9000 Series Installation and Programming Guide 7
PROGRAM THE KEYPAD
The keypads can be programmed into the control panel by entering the serial number
in Device Setup or using the wireless keypad association operation. A maximum of
4 keypads may be used with the XT30/XT50 panel, 7 keypads with XR150/XR550 panels
using Version 191 software or higher, and 7 keypads with XTLplus/XTLtouch panels.
Device Setup Programming
Program the keypad as a device in Device Setup during panel programming. At the serial
number prompt, enter the 8-digit serial number. Continue to program the device as
directed in the panel programming guide.
Note : If the keypad serial number is entered manually, the Wireless Keypad
Association operation is not required.
Wireless Keypad Association
Enable Wireless Keypad Association operation on both the keypad and panel.
To enable association operation in the keypad, access the Installer Options Menu and
select RF Survey. The keypad logo LEDs turn red until association is successful.
To enable association operation in XR150/XR550, XT30/XT50, and XTLplus/XTLtouch
panels, reset the panel 3 times within 12 seconds. Allow the keypad bus Transmit/Receive
LEDs to turn back on between each reset.