DMC SuperSigma2, Advanced Manual

Page: 41 / 97

SuperSigma2 AM PMS – V1.5.6 17-1-2020 Page 41 (97) ©2019 DMC GmbH Herten Germany
The following graph shows an example of how these settings work with each other.
When the setting “ M3-14TSingle or Dual Motor ” Si/DL/DR ” is set to 3, the speed is limited according to the following
figure:
Speed limiting when “ M3-14T Single or Dual Motor ” Si/DL/DR ” , is set to 3
In the figure an example is reported for “ M1-61T Dual motor cu t out ”DMcut”” =10%, “ M1-64T Dual motor angle 3
”DMang3”” 85% and “ M1-67T Dual motor speed 3 ”DMspd3”” 60%.
•
If the steering pot is between ±10%, the speed limit is kept to 100% and it corresponds to a central dead band.
•
If the steering pot. is between 10% and 85% (left or right) the speed limit is reduced gradually to 60%.
•
If steering pot is greater than 85% speed limit is kept to 60%.
The speed limit is expressed as percentage of parameter “ M4-13 Maximum Motor Frequency ” . In fact, if for example
“ M4-13 Maximum Motor Frequency ” is set to 140Hz and “ M1-67T Dual motor speed 3 ”DMspd3”” is set to 60%, the
speed limit with steering pot at 100% (left or right) will be 84 Hz.
! IMPORTANT If any speed limit is active the percentage of speed will refer to that speed limit and not
to the
“ M4-13 Maximum Motor Frequency “Fmotmax”” .