Initial operation
40
User’s Manual V1.00
DLoG MTC 6
5.6.
Connecting external devices
The DLoG MTC 6 must be disconnected from the power supply:
•
before external devices (e.g., scanner, keyboard) are connected or disconnected
•
and before the DLoG MTC 6 can be connected to a network.
All connections and interfaces on the DLoG MTC 6 are located on the underside of the
unit.
Caution:
Property
damage
Make sure that external peripheral devices with their own power
supply are switched on at the same time as the DLoG MTC 6 or
after you start the DLoG MTC 6. If this is not possible, please
ensure that the DLoG MTC 6 is adequately protected from power
leakage caused by an external device.
Only power up the DLoG MTC 6 when all devices have been
connected and the DLoG MTC 6 has been closed correctly
(remember the cable cover!). Otherwise, you may damage the
DLoG MTC 6.
5.6.1.
Powering down the DLoG MTC 6
Always shut down the DLoG MTC 6 as follows:
1.
Power down the device using the ignition input or the <Power>-key.
2.
Remove the cable cover.
3.
Disconnect the device from the DC supply voltage (pull the plug).
