Basic safety guidelines
DLoG MTC 6
User’s Manual V1.00
7
Laying power supply cables – observe the local installation regulations
The power supply cables must be laid in accordance with the applicable local
installation regulations.
Ensure that no persons are injured in case the mounting bracket breaks
The DLoG MTC 6/10 may in no case be installed in such a way that persons can be
injured during a breaking of the mounting bracket (e.g. fatigue break).
If the device is mounted in a place where people can be injured if the bracket should
break, appropriate safety measures must be put in place (e.g. install a security cable
in addition to the device bracket).
Radio performance: Do not exceed the maximum permissible transmitting power
Do not exceed the maximum permissible transmitting power which is specified by
each separate country. DLoG MTC 6 users must verify this themselves.
2.5.
Power supply
Operation in an emergency: immediately disconnected the device from the power
supply
In case of emergency (such as damage to the power cable , or housing, or ingress of
liquid or other foreign bodies), the device must be disconnected immediately from the
power supply. Contact technical support staff at once.
Protection of the power supplies
If, after replacement, the fuse fed by the internal power supply blows again, the device
must be sent in for servicing immediately.
Danger of electrocution when cleaning/servicing the device
In order to avoid electrocution always disconnect the DLoG MTC 6 from the power
supply before cleaning or servicing the device.
When charging the vehicle battery please note
While charging the vehicle battery the DLoG MTC 6 has to be either disconnected
from the battery or it has to be determined that the maximum allowed input voltage of
the DLoG MTC 6 is not exceeded.
