9024-065-G-11-14
31
1 2 3
4
5 6
7 8 9 10
12345678
ON
12345678
ON
1
2
3
4
5
6
7
8
9
10
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
EXIT
LOOP
REVERSE
LOOP
IN POWER/BATT
PWR
SEL
REV SENSE
JUMPER ON
SOLAR MODE
P3
SELF TEST
RESET
RED=CHARGING
GREEN=CHARGED
KEY
SWITCH
NO
NC
3 BUTTON
CONTROL
SW1
SW2
OFF
ON
POWER
P4
P2
1
6
TIME DELAY
Gate Frame
Non-Secure Side
Outside Property
Secure Side
Inside Property
Filler Post or Barrier
Reversing Edge (Open Contact Sensor)
5.2 Secondary Entrapment Protection Device Locations
Photo Sensors (With Filler Post and Reverse Edge) Sample Setup
Typical UL Photo Sensor mounting height
and distance away from gate.
Gate Frame
If the distance between the gate
and wall is greater than 2 1/4”.
Wall
UL sensor mounted on post.
UL sensor mounted on wall.
Closed Gate
Wall
Normally Open
Normally Open
Normally Open
Common
Common
Common
Common
Normally Open
A filler post or barrier may need to be installed between the
gate and wall area to reduce the distance to 2 1/4”
or less
.
A reversing edge should be installed on the post or barrier
for safety (See page 4 for more information).
Photo Sensor Power Note:
Photo sensors can be powered by the built-in convenience
outlets (model 9024-080 ONLY) located on the operator (See previous page).
IF
the closing-direction photo sensor
is wired to the #10 main terminal, a
closing-direction photo
beam that gets obstructed
will
REVERSE
the gate
back to the open position.
Closing-direction photo sensors wired to UL 325 terminal.
Closing-Direction Photo Beam
Opening-Direction Photo Beam
UL 325 Terminal Wiring
“Reverse” Closing-Direction Option
Filler Post with Opening-Direction Reversing Edge (If necessary, see above)
SW 1, switch 4
MUST
be
OFF
.
IF
the closing-direction photo sensor is wired to the UL 325 terminal, a
closing-direction photo beam that gets obstructed will
STOP
the gate, then
resume closing the gate when the obstructed photo beam has been cleared.
Photo sensors may be installed on either side of gate frame, as close as
practical to the gate but no further away than 5”.
No higher than
27.5” above grade.
21” is typical for
most installations.
Note: Additional
photo sensors can
be added above
the 27.5” height.
5”
or
Less
5”
or
Less
ON
12
3
4
5678
SW 1
Note: Terminal
descriptions
on page 30.
Summary of Contents for 9024
Page 2: ......
Page 47: ...9024 065 G 11 14 45...
