APPENDIX 1B - SETTING THE SENSING WINDOW
Setting the Sensing Window
Note: For manual setup use the external contact in place of button G.
1.
Install accessory XXZPB100
2.
Remove all objects from the sensor’s field of detection
3.
Align the sensor with the object to be detected
4.
Push and hold the setup button (G) until the bicolor LED (D) rapidly flashes green
5.
Releases the button. The bicolor LED continues to flash green
6.
Within 30s, insert an object into position 1, then push and release the setup button. The bicolor LED flashes green, then turns steady amber
The device is set up properly if:
• The LED turns amber when an object is sensed in the window.
• The LED turns green when an is not sensed
To reset the sensor, repeat Step 4.
When setup is complete, disconnect power and remove accessory XXZPB100
Reconnect power to the sensor
16
Summary of Contents for TYPHOON WX Series
Page 19: ...19 NOTES...
