Diversified Power International Accusense Charge 1-48C017C Series, Instruction Manual

Page: 5 / 14

5
5. Grounding Instructions
This battery charger must be grounded to reduce the risk of electric
shock. This charger is equipped with an AC cord set having an
equipment-grounding conductor. This AC cord set must be connected to
an appropriate receptacle that is properly installed and grounded in
accordance with the National Electrical Code and all local codes and
ordinances.
WARNING: IMPROPER CONNECTION OF THE EQUIPMENT-
GROUNDING CONDUCTOR CAN RESULT IN A RISK OF AN
ELECTRIC SHOCK.
The conductor with insulation having an outer surface that is green, with
or without yellow stripe(s), is the equipment-grounding conductor. If repair
or replacement of the charger’s AC cord set is necessary, refer to a
qualified service agent, and do not connect the equipment-grounding
connector to a live terminal.
6. Preparing to Charge
The instructions printed on the charger are for daily reference. The charger is
factory preset to charge using one of four operating MODES. Each mode is set to
charge a particular Battery Pack as listed:
Mode 1: 48V ‘US Battery’ made Battery
Mode 2: Trojan T875 Battery
Mode 3: Trojan T105 Battery
Mode 4: Use for 36v Mode
Upon connection to Battery Pack, all five L.E.D.s flash on, then off, up to 4 times.
The charger is communicating the Mode Setting to you. Simply count the number
of times you see all five L.E.D.s turn on, and off. This MODE is preset at the
factory.
WARNING: ENSURE THE CHARGER IS CORRECTLY MATCHED
TO THE BATTERY PACK. DAMAGE TO THE CHARGER AND
BATTERIES, OR PERSONAL OR PROPERTY DAMAGE MAY RESULT
IF THIS CHARGER IS USED ON THE WRONG BATTERY TYPE.
6.1 Be sure area around battery is well ventilated while battery is being
charged. Gas can be forcefully blown away using a non-metallic
material like cardboard.
WARNING: TO REDUCE THE RISK OF AN ELECTRIC SHOCK,
CONNECT ONLY TO A PROPERLY GROUNDED, SINGLE-PHASE (3-
WIRE) OUTLET. ALSO, REFER TO GROUNDING INSTRUCTIONS.