8. Use the hex end of the In-Line Adjusting Tool or 3/16” hex wrench to loosen the Orifice (13) in the
Adjust Tube. Push the Orifice out with a thin wooden dowel from the threaded end. Do not use a metal
tool. Remove the O-ring (14*) from the Orifice - Fig. 18.
Fig. 18
9. The disassembled Adjust Tube assembly with the Heat Sink Nut is shown below. Note that the O-
ring (04*) from under the Heat Sink Nut is similarly sized, but thicker than the O-ring (20*) from the
Adjust Tube - Fig. 19.
Fig. 19
Summary of Contents for DGX Gears D6
Page 1: ...DGX Gears D6 Second Stage Service Manual...
Page 32: ......
