CAUTION:
If malfunctions occur while using the device or if you wish to immediately
stop the application, press and hold the key ( ) (
Fig. 3
). Every time a key is pressed,
an acoustic signal (beep) is generated.
Fig. 4
4
Step 2:
Insert one or two connecting cable(s) in the connector
socket(s) of the device (see
Fig. 1
). Afterwards, connect the
adhesive electrodes to the device by means of the plug connec-
tions (see
Fig. 2
). The device must be switched off when
establishing the connection!
15
Step 3:
Remove the adhesive electrodes from the protective
foil and position them according to the application examples on
the pages 27-33.
Warning!
Observe the safety instructions!
Fig. 2
protection film
plug
connection
Fig. 1
Fig. 3
4
Step 7:
If you wish to reposition the adhesive electrodes, make
sure that you switch off the device first and repeat the steps
3
to
5
.
Step 6:
The application time can only be adjusted for the
U
programmes. For the
P
programmes, the application time is 30
minutes.
Step 1:
Insert 4 batteries (type AAA) observing the polarity
marking of the batteries (see section 7.0 on page 12). When
inserting the batteries in the device, observe the correct polarity
(+(positive) and –(negative) pole). Do not switch
on the device!
10.0 Quick overview for commissioning
QUICK OVERVIEW
12
8
10
13
14
15
16
18
17
4
Step 4:
In order to switch on the device, press the start key
( )
(
Fig. 3
). Set the desired application programme by using
the keys
(T) = TENS
,
(E) = EMS
or
(M) = MASSAGE
.
Furthermore, you can select special programmes for the indica-
ted parts of the body by using the one-touch keys
(B) =
back
,
(K) = knee joint
,
(N) = neck
,
(E) = elbow
joint
,
(H) = hand
and
(F) = foot
.
5
11
7
9
3
Step 8:
In order to switch off the device, press and hold the key
(
Fig. 3
) Remove the plug of the connecting cable from the device and the adhesive
electrodes. Then, remove the adhesive electrodes from the body and stick them back on
the protective foil (
Fig. 2
).
NOTE:
If none of the keys is pressed, the device switches off
automatically after three minutes provided that it is not in the operating state.
Step 5:
Press the key
(CH1 )
or
(CH2 )
in order to
increase the output intensity of channel 1
(CH1)
or channel
(CH2)
and to start the application. Press the key
(CH1 )
or
(CH2 )
, in order to reduce the output intensity of channel 1
(CH1)
or channel 2
(CH2)
. On the display of the device, the
selected output intensity as well as the remaining application
duration will be shown. Each application starts from the intensity
level
1
for each channel. You can read the current intensity
setting on the display (see ,
Fig. 4
: Information about the
output intensity (here, e. g.
60 mA
) in
mA
(milliampere) for
channel
CH1
(left) und
CH2
(right).
GB
4. PJN157-14_GA-GB_HHD_TEN250_31.03.14
Montag, 31. M
rz 2014 12:10:41
