3
Basic Data
Safety and Electromagnetic Compatibility (EMC)
The systems comply with the standards and directives mentioned in the appli-
cable CE declaration.
Please take note of the following safety measures:
Do only connect the system to an earthed mains power
socket of 230 V, 50 Hz.
Do not place hot blocks on inflammable or not heat-resistant
surfaces.
Make sure to only use containers in the block which are suit-
able for the desired temperature range.
If liquid gets into the system, immediately pull out the plug
and contact our service department to ensure complete
safety.
Please do not touch or transport hot systems.
Contact with highly flammable fluids must be avoided.
The ventilation of the device must not be blocked. To ensure
the proper ventilation at all times please consider a mini-
mum distance of 10 centimeter on each side of the device.
Damaged mains cable should only be replaced with equal
ones.
Warranty
All functions of the systems have been tested thoroughly. After that, the sys-
tem and the accessories were packed carefully in perfect condition.
If, however, any damages or defects are detected during installation or setup,
please inform DITABIS immediately (see our Terms and Conditions at
www.ditabis.de).
If used under normal laboratory conditions according to the Operating Manu-
al, DITABIS grants a warranty of 1 year for the material and workmanship,
starting with the day of shipment.
Disclaimer of warranty
In case of unspecified use of the device, the manufacturer assumes no re-
sponsibility.
Summary of Contents for HLC MHL 23
Page 25: ...25 800 68 13 02_Manual_Smart_Control docx...
Page 26: ...26...
