Distform MyChef 10 GN 1/1, Installation, Use And Maintenance Manual, Page: 9 / 63

130
4. RECEIPT, TRANSPORT, AND POSITIONING
Before installing, verify the dimensions of the area where the appliance will be
installed and verify the electrical and water connections to ensure they are within
the parameters indicated in the installation sheet attached in chapter 6.
4.1 Receipt
Once the oven has been received, check that the model corresponds to the model
ordered.
Check to ensure that no damage occurred during transport and that no pieces
or parts of the appliance are missing. If any abnormality or problem is detected,
contact the distributor immediately.
4.2 Transport
The appliance should be transported with the original packaging until reaching the
site closest to the installation area in order to minimize the possibility of damages.
It is recommended that the original packaging be kept intact until the appliance is
correctly installed and functioning.
To move the appliance and place it in the workspace, note the appliance dimensions:
- Note the following dimensions for the different models when moving
appliance through narrow areas (hallways, doors, narrow spaces):
Model Dimensions (Width x Depth x Height)
4GN 2/3
520 x 625 x 575 mm
4 GN 1/1 520 x 799 x 575 mm
6GN 2/3
520 x 625 x 694mm
6GN 1/1 520 x 799 x 694 mm
10GN 1/1 520 x 799 x 935 mm
Table 2: Exterior dimensions for the different models.
-
Use appropriate staff to handle and move the appliance, keeping in mind
current work safety standards at the installation site.
- The oven must always be in a vertical position during movement. Lift the
oven perpendicular to the ground and transport it parallel to the ground.
-
Be sure that during transport, it does not overturn or hit any object.